Aziz Packaging Limited supplies kraft paper yarn cones to Pakistani spinning mills from Bangladesh as an additional source — not as a replacement for Pakistan's own established paper cone manufacturing base. Imports from Bangladesh typically happen for one of two reasons: domestic supply is capacity-constrained, or a mill needs a specification that isn't readily available from a local supplier on short notice.
We manufacture kraft paper yarn cones in Bangladesh for spinning mills — see our paper cone for spinning mills page for standard specifications. This page covers the hubs we ship to, the shipping route, and the technical specification.
Key Specifications at a Glance
| Attribute | Value |
|---|---|
| Taper Angles | 4°20′ and 5°57′ |
| Surface Finish | Smooth, velvet, or embossed |
| Machine Compatibility | Murata, Savio, Schlafhorst |
| Shipping Route | FOB Chattogram to Karachi |
| HS Code / Duty | 4822.10.00 — approx. 20% MFN duty |
Textile Hubs We Serve
We ship to spinning mills across Pakistan's major textile manufacturing regions, including:
- Faisalabad
- Multan
- Karachi
- Lahore
Shipping Route
We quote FOB Chattogram (Chittagong). From there, containerised cargo moves to Karachi with established carrier services — the primary port serving Pakistan's spinning mills, including those inland at Faisalabad, Multan and Lahore. Your freight forwarder will confirm current transit times and onward inland freight for your specific route.
For the full breakdown of what FOB Chattogram covers and what the buyer arranges, see our FOB Chattogram export terms page.
HS Code and Import Duty
Paper cones classify under HS code 4822.10.00. Pakistan applies its standard MFN duty rate of approximately 20% to this HS code regardless of country of origin — Bangladesh's SAARC membership does not currently translate into a preferential rate for this product under SAFTA, due to Pakistan's sensitive list. That means the sourcing decision comes down to FOB price, freight and specification fit rather than a duty advantage. See our HS code and import duty guide for the full country-by-country table and required documents.
Taper Angles and Finishes
Standard specification for the Pakistani market matches what we supply everywhere else — the same taper angles and finishes used across most autoconer and cone winder setups, listed in the "Key Specifications at a Glance" table above. Material is kraft paperboard, produced on fully automatic or manual production lines. For full dimensional specifications by taper angle, see our paper cone specifications page.
Machine Compatibility
We manufacture to the same autoconer standards that much of the installed base in Pakistan runs on — Murata, Savio, and Schlafhorst. Confirm your machine model and required taper angle when requesting a quote and we'll confirm the correct specification.
Request a Quote
Send your machine model, taper angle, finish, quantity and destination port on WhatsApp and we'll confirm specification and lead time. We recommend a comparative sample batch against your current supply rather than switching outright, and planning order timing around the full lead time from Bangladesh rather than treating it as an emergency source.